十字星 — 指標和策略

Twisted Forex's Doji + Area Strategy Title Twisted Forex’s Doji + Area Strategy Description What this strategy does This strategy looks for doji candles forming inside or near supply/demand areas . Areas are built from swing pivots and sized with ATR, then tracked for retests (“confirmations”). When a doji prints close to an area and quality checks pass, the strategy places a trade with the stop beyond the doji and a configurable R:R target. How areas (zones) are built • Swings are detected with a user-set pivot length. • Each swing spawns a horizontal area centered at the pivot price with half-height = zoneHalfATR × ATR . • Duplicates are de-duplicated by center distance (ATR-scaled). • Areas fade when broken beyond a buffer or after an optional age (expiry). • Retests are recorded when price touches and then bounces away from the area; repeated reactions increase the zone’s “strength”. Signal logic (summary) Doji detection: strict or loose body criteria with optional minimum wick fractions and ATR-scaled minimum range. Proximity: price must be inside/near a supply or demand area (proxATR × ATR). Side resolution: overlap is resolved by (a) which side price penetrates more, (b) fast/slow EMA trend, or (c) nearest distance. Optional “previous candle flip” can bias long after a bearish candle and short after a bullish one. Optional 1-bar confirmation: the bar after the doji must close away from the area by confirmATR × ATR . Quality filter (Off/Soft/Strict): four checks—(i) wick rejection past the edge, (ii) doji closes in an edge “band” of the area, (iii) fresh touch (cooldown), (iv) approach impulse over a short lookback. In Strict , thresholds auto-tighten. Orders & exits • Long: stop below doji low minus buffer; Short: above doji high plus buffer. • Target = rrMultiple × risk distance . • Pyramiding is off by default. Position sizing You can size from the script or from Strategy Properties: • Script-driven (default): set Position sizing = “Risk % of equity” and choose riskPercent (e.g., 1.0%). The script applies safe floors/rounding (FX micro-lots by default) so quantity never rounds to zero. • Properties-driven : toggle Use TV Properties → Order size ON, then pick “Percent of equity” in Properties (e.g., 1%). The header includes safe defaults so trades still place. Key inputs to explore • Zone building : pivotLen, zoneHalfATR, minDepartureATR, expiryBars, breakATR, leftBars, dedupeATR. • Doji & proximity : strictDoji, dojiBodyFrac, minWickFrac, minRangeATR, proxATR, minBarsBetween. • Overlap resolution : usePenetration, useTrend (EMA 21/55), “previous candle flip”, needNextBarConf & confirmATR. • Quality : qualityMode (Off/Soft/Strict), minQualPass/kStrict, wickPenATR, edgeBandFrac, approachLookback, approachMinATR, freshTouchBars. • Zone strength gating : minStrengthSoft / minStrengthStrict. • HTF confluence (optional) : useHTFTrend (HTF EMA 34/89) and/or useHTFZoneProx (HTF swing bands). Tips to make it cleaner / higher quality • Turn needNextBarConf ON and use confirmATR = 0.10–0.15 . • Increase approachMinATR (e.g., 0.35–0.45) to require a stronger pre-touch impulse. • Raise minStrengthSoft/Strict (e.g., 4–6) so only well-reacted zones can signal. • Use signalsOnlyConfirmed ON if you prefer trades only from zones with retests (the script falls back gracefully when none exist yet). • Nudge proxATR to 0.5–0.6 to demand tighter proximity to the level. • Optional: enable useHTFTrend to filter counter-trend setups. Default settings used in this publication • Initial capital: 100,000 (illustrative). • Slippage: 1 tick; Commission: 0% (you can raise commission if you prefer—spread is partly modeled by slippage). • Sizing: Risk % of equity via inputs; riskPercent = 1.0% ; FX uses micro-lot floors by default. • Quality: Off by default (Soft/Strict available). • HTF trend gate: Off by default. Backtesting notes For a meaningful sample size, test on liquid symbols/timeframes that yield 100+ trades (e.g., majors on 5–15m over 1–2 years). Backtests are modelled and broker costs/spread vary—validate on your feed and forward-test. How to read the chart Shaded bands are supply (above) and demand (below). Brighter bands are the nearest K per side (visual aid). BUY/SELL labels mark entries; colored dots show entry/SL/TP levels. You can hide zones or unconfirmed zones for a cleaner view. Disclaimer This is educational material, not financial advice. Trading involves risk. Always test and size responsibly.

Price Action Strategy The **Price Action Strategy** is a tool designed to capture potential market reversals by utilizing classic reversal candlestick patterns such as Hammer, Shooting Star, Doji, and Pin Bar near dinamic support and resistance levels. ***Note to moderators - The moving average was removed from the strategy because it was not suitable for the strategy and not participating in the entry or exit criteria. - The moving average length has been replaced/renamed by the support/resistance lenght. - The bullish engulfing and bearish engulfing patterns were also removed because in practice they were not working as entry criteria, since the candle price invariably closes far from the support/resistance level even considering the sensitivity range. There was no change in the backtest results after removing these patterns. ### Key Elements of the Strategy 1. Support and Resistance Levels - Support and resistance are pivotal price levels where the asset has previously struggled to move lower (support) or higher (resistance). These levels act as psychological barriers where buying interest (at support) or selling interest (at resistance) often increases, potentially causing price reversals. - In this strategy, support is calculated as the lowest low and resistance as the highest high over a 16-period length. When the price nears these levels, it indicates possible zones for a reversal, and the strategy looks for specific candlestick patterns to confirm an entry. 2. Candlestick Patterns - This strategy uses classic reversal patterns, including: - **Hammer**: Indicates a buy signal, suggesting rejection of lower prices. - **Shooting Star**: Suggests a sell signal, showing rejection of higher prices. - **Doji**: Reflects indecision and potential reversal. - **Pin Bar**: Represents price rejection with a long shadow, often signaling a reversal. By combining these reversal patterns with the proximity to dinamic support or resistance levels, the strategy aims to capture potential reversal movements. 3. Sensitivity Level - The sensitivity parameter adjusts the acceptable range (Default 0.018 = 1.8%) around support and resistance levels within which reversal patterns can trigger trades (i.e. the closing price of the candle must occur within the specified range defined by the sensitivity parameter). A higher sensitivity value expands this range, potentially leading to less accurate signals, as it may allow for more false positives. 4. Entry Criteria - **Buy (Long)**: A Hammer, Doji, or Pin Bar pattern near support. - **Sell (Short)**: A Shooting Star, Doji, or Pin Bar near resistance. 5. Exit criteria - Take profit = 9.5% - Stop loss = 16% 6. No Repainting - The Price Action Strategy is not subject to repainting. 7. Position Sizing by Equity and risk management - This strategy has a default configuration to operate with 35% of the equity. The stop loss is set to 16% from the entry price. This way, the strategy is putting at risk about 16% of 35% of equity, that is, around 5.6% of equity for each trade. The percentage of equity and stop loss can be adjusted by the user according to their risk management. 8. Backtest results - This strategy was subjected to deep backtest and operations in replay mode on **1000000MOGUSDT.P**, with the inclusion of transaction fees at 0.12% and slipagge of 5 ticks, and the past results have shown consistent profitability. Past results are no guarantee of future results. The strategy's backtest results may even be due to overfitting with past data. 9. Chart Visualization - Support and resistance levels are displayed as green (support) and red (resistance) lines. - Only the candlestick pattern that generated the entry signal to triger the trade is identified and labeled on the chart. During the operation, the occurrence of new Doji, Pin Bar, Hammer and Shooting Star patterns will not be demonstrated on the chart, since the exit criteria are based on percentage take profit and stop loss. Doji: Pin Bar and Doji Shooting Star and Doji Hammer 10. Default settings Chart timeframe: 20 min Moving average lenght: 16 Sensitivity: 0.018 Stop loss (%): 16 Take Profit (%): 9.5 BYBIT:1000000MOGUSDT.P

Pure Morning 2.0 - Candlestick Pattern Doji Strategy The new "Pure Morning 2.0 - Candlestick Pattern Doji Strategy" is a trend-following, intraday cryptocurrency trading system authored by devil_machine. The system identifies Doji and Morning Doji Star candlestick formations above the EMA60 as entry points for long trades. For best results we recommend to use on 15-minute, 30-minute, or 1-hour timeframes, and are ideal for high-volatility markets. The strategy also utilizes a profit target or trailing stop for exits, with stop loss set at the lowest low of the last 100 candles. The strategy's configuration details, such as Doji tolerance, and exit configurations are adjustable. In this new version 2.0, we've incorporated a new selectable filter. Since the stop loss is set at the lowest low, this filter ensures that this value isn't too far from the entry price, thereby optimizing the Risk-Reward ratio. In the specific case of ALPINE, a 9% Take-Profit and and Stop-Loss at Lowest Low of the last 100 candles were set, with an activated trailing-stop percentage, Max Loss Filter is not active. Name : Pure Morning 2.0 - Candlestick Pattern Doji Strategy Author : @devil_machine Category : Trend Follower based on candlestick patterns. Operating mode : Spot or Futures (only long). Trades duration : Intraday Timeframe : 15m, 30m, 1H Market : Crypto Suggested usage : Short-term trading, when the market is in trend and it is showing high volatility . Entry : When a Doji or Morning Doji Star formation occurs above the EMA60. Exit : Profit target or Trailing stop, Stop loss on the lowest low of the last 100 candles. Configuration : - Doji Settings (tolerances) for Entry Condition - Max Loss Filter (Lowest Low filter) - Exit Long configuration - Trailing stop Backtesting : ⁃ Exchange: BINANCE ⁃ Pair: ALPINEUSDT ⁃ Timeframe: 30m ⁃ Fee: 0.075% ⁃ Slippage: 1 - Initial Capital: 10000 USDT - Position sizing: 10% of Equity - Start: 2022-02-28 (Out Of Sample from 2022-12-23) - Bar magnifier: on Disclaimer : Risk Management is crucial, so adjust stop loss to your comfort level. A tight stop loss can help minimise potential losses. Use at your own risk. How you or we can improve? Source code is open so share your ideas! Leave a comment and smash the boost button! Thanks for your attention, happy to support the TradingView community.

Doji swing strategy This is a simple strategy based on Doji star candlestick This strategy is suited for big time frames, like 4h -1Day and so on. It places two orders: long at doji star high or previous candle high and short at doji star low or previous candle low. It can also be applied volume average, in order to filter between trades . This strategy works very well with high time frames like Weekly TF because it eliminates the noise in doji formation. It also has inside a risk management made of SL/TP , or if not prefered it can exit based on a exit condition. If you have any questions, please let me know !

Doji Backtest This is a candlestick where the open and close are the same. WARNING: - For purpose educate only - This script to change bars colors.

Doji strategy This is a simple strategy based on Doji star candlestick. It places two orders: buy stop at doji star high or previous candle high and sell stop at doji star low or previous candle low. Exit rules are with take profit and fixed stop loss or take profit and stop loss at doji min or max. This strategy works very well with high time frames like Daily and Weekly because those are without noise in doji formation. Each currency pair has its own optimal setting for TP and SL: it's up to user find the best ones. I could implement SL based on ATR, maybe in next revision. Please use comment section for any feedback. Next improvement (only to whom is interested to this script and follows me): study with alerts on multiple tickers all at one. Leave a comment if you want to have access to study.